Dernières Cisco 100-101 examen pratique questions et réponses

Les spécialistes d'expérience de Pass4Test ont fait une formation ciblée au test Cisco 100-101. Cet outil de formation est convenable pour les candidats de test Cisco 100-101. Pass4Test n'offre que les produits de qualité. Vous aurez une meilleure préparation à passer le test avec l'aide de Pass4Test.

Si vous voulez ne se soucier plus à passer le test Cisco 100-101, donc vous devez prendre la Q&A de Pass4Test comme le guide d'étude pendant la préparation de test Cisco 100-101. C'est une bonne affaire parce que un petit invertissement peut vous rendre beaucoup. Utiliser la Q&A Cisco 100-101 offerte par Pass4Test peut vous assurer à réussir le test 100%. Pass4Test a toujours une bonne réputation dans l'Industrie IT.

Aujoud'hui, c'est une société de l'informatique. Beaucoup d'organisations peut provider l'outil de se former pour le test Certification Cisco 100-101. Mais on doit admettre que ces site n'ont pas la capacité à offrir une bonne Q&A, elles sont généralement très vagues et sans les points. C'est loin d'attirer les attentions des candidats.

Code d'Examen: 100-101

Nom d'Examen: Cisco (CCNA Interconnecting Cisco Networking Devices 1 (ICND1))

Questions et réponses: 102 Q&As

Le test Certification Cisco 100-101 est une chance précieuse à augmenter vos connaissances de technologie informatique dans l'industrie IT. Il attire beaucoup de professionls à participer ce test. Pass4Test peut vous offrir les outils de formation particuliers à propos de test Cisco 100-101. Vous réaliserez plus tôt votre rêve avec la Q&A écrite par l'équipe professionnelle de Pass4Test. Pass4Test se contribue à vous donner un coup de main pour réussir le test Cisco 100-101.

Le produit de Pass4Test peut assurer les candidats à réussir le test Cisco 100-101 à la première fois, mais aussi offrir la mise à jour gratuite pendant un an, les clients peuvent recevoir les ressources plus nouvelles. Pass4Test n'est pas seulement un site, mais aussi un bon centre de service.

100-101 Démo gratuit à télécharger: http://www.pass4test.fr/100-101.html

NO.1 Refer to the exhibit.
HostX is transferring a file to the FTP server. Point A represents the frame as it goes toward the
Toronto router. What will the Layer 2 destination address be at this point?
A. abcd.1123.0045
B. 192.168.7.17
C. aabb.5555.2222
D. 192.168.1.1
E. abcd.2246.0035
Answer: E

Cisco   100-101   100-101   100-101   100-101   100-101
Explanation:
For packets destined to a host on another IP network, the destination MAC address will be the LAN
interface of the router. Since the FTP server lies on a different network, the host will know to send
the frame to its default gateway, which is Toronto.

NO.2 Which three statements are true about the operation of a full-duplex Ethernet network?
(Choose three.)
A. There are no collisions in full-duplex mode.
B. A dedicated switch port is required for each full-duplex node.
C. Ethernet hub ports are preconfigured for full-duplex mode.
D. In a full-duplex environment, the host network card must check for the availability of the network
media before transmitting.
E. The host network card and the switch port must be capable of operating in full-duplex mode.
Answer: A,B,E

Cisco   100-101   100-101   100-101 examen

NO.3 Which protocol uses a connection-oriented service to deliver files between end systems?
A. TFTP
B. DNS
C. FTP
D. SNMP
E. RIP
Answer: C

certification Cisco   100-101   100-101   100-101   100-101   certification 100-101
Explanation:
FTP is an acronym for File Transfer Protocol. As the name suggests, FTP is used to transfer files
between computers on a network. You can use FTP to exchange files between computer accounts,
transfer files between an account and a desktop computer, or access online software archives

NO.4 Which layer of the TCP/IP stack combines the OSI model physical and data link layers?
A. Internet layer
B. transport layer
C. application layer
D. network access layer
Answer: D

certification Cisco   100-101   100-101
Explanation:
The Internet Protocol Suite, TCP/IP , is a suite of protocols used for communication over the internet.
The TCP/IP model was created after the OSI 7 layer model for two major reasons. First, the
foundation of the Internet was built using the TCP/IP suite and through the spread of the World
Wide Web and Internet, TCP/IP has been preferred. Second, a project researched by the
Department of Defense (DOD) consisted of creating the TCP/IP protocols. The DOD's goal was to
bring international standards which could not be met by the OSI model. Since the DOD was the
largest software consumer and they preferred the TCP/IP suite, most vendors used this model rather
then the OSI. Below is a side by side comparison of the TCP/IP and OSI models.
TCP/IP Model VS. OSI Model Application Layer 7 Application Layer 6 Presentation Layer 5 Session
Transport Layer 4 Transport Internet Layer 3 Network Network Access Layer 2 Data Link Layer 1
Physical

NO.5 Refer to the exhibit.
If the hubs in the graphic were replaced by switches, what would be virtually eliminated?
A. broadcast domains
B. repeater domains
C. Ethernet collisions
D. signal amplification
E. Ethernet broadcasts
Answer: C

Cisco   100-101   100-101   100-101 examen
Explanation:
Modern wired networks use a network switch to eliminate collisions. By connecting each device
directly to a port on the switch, either each port on a switch becomes its own collision domain (in
the case of half duplex links) or the possibility of collisions is eliminated entirely in the case of full
duplex links.

NO.6 Refer to the exhibit.
The host in Kiev sends a request for an HTML document to the server in Minsk. What will be the
source IP address of the packet as it leaves the Kiev router?
A. 10.1.0.1
B. 10.1.0.5
C. 10.1.0.6
D. 10.1.0.14
E. 10.1.1.16
F. 10.1.2.8
Answer: E

Cisco examen   100-101   100-101   100-101
Explanation:
Although the source and destination MAC address will change as a packet traverses a network, the
source and destination IP address will not unless network address translation (NAT) is being done,
which is not the case here.

NO.7 Which OSI layer header contains the address of a destination host that is on another network?
A. application
B. session
C. transport
D. network
E. data link
F. physical
Answer: D

Cisco   100-101   100-101   certification 100-101
Explanation:
Only network address contains this information. To transmit the packets the sender uses network
address and datalink address. But the layer 2 address represents just the address of the next hop
device on the way to the sender. It is changed on each hop. Network address remains the same.

NO.8 Refer to the exhibit.
If host A sends an IP packet to host B, what will the source physical address be in the frame when it
reaches host B?
A. 10.168.10.99
B. 10.168.11.88
C. A1:A1:A1:A1:A1:A1
D. B2:B2:B2:B2:B2:B2
E. C3:C3:C3:C3:C3:C3
F. D4:D4:D4:D4:D4:D4
Answer: E

Cisco examen   certification 100-101   certification 100-101   100-101   100-101
Explanation:
When packets transfer from one host to another across a routed segment, the source IP address
always remains the same source IP address, and the source physical (MAC) address will be the
existing router's interface address. Similarly, the destination IP address always remains the same
and the destination physical (MAC) address is the destination router's interface address.

Si vous choisissez notre l'outil formation, Pass4Test peut vous assurer le succès 100% du test Cisco 100-101. Votre argent sera tout rendu si vous échouez le test.